AISC 360-22

Overview

AISC 360-22, Specification for Structural Steel Buildings, published by the American Institute of Steel Construction. Approved August 1, 2022 by the Committee on Specifications. Supersedes the Specification for Structural Steel Buildings dated June 7, 2016, and all previous versions. This edition is organised in 44 parts covering structural requirements; open any part below or from the panel on the left.

Table of Contents

1. 01Appendix 1 Design by advanced analysis
2. 02Appendix 2 Design of filled composite members (high strength)
3. 03Appendix 3 Fatigue
4. 04Appendix 4 Structural design for fire conditions
5. 05Appendix 5 Evaluation of existing structures
6. 06Appendix 6 Member stability bracing
7. 07Appendix 7 Alternative methods of design for stability
8. 08Appendix 8 Approximate analysis
9. 09Chapter A General provisions
10. 10Chapter B Design requirements
11. 11Chapter C Design for stability
12. 12Chapter D Design of members for tension
13. 13Chapter E Design of members for compression
14. 14Chapter F Design of members for flexure
15. 15Chapter G Design of members for shear
16. 16Chapter H Design of members for combined forces and torsion
17. 17Chapter I Design of composite members
18. 18Chapter J Design of connections
19. 19Chapter K Additional requirements for HSS and box-section connections
20. 20Chapter L Design for serviceability
21. 21Chapter M Fabrication and erection
22. 22Chapter N Quality control and quality assurance
23. 23Commentary — Appendix 1 Design by advanced analysis
24. 24Commentary — Appendix 2 Design of filled composite members (high strength)
25. 25Commentary — Appendix 3 Fatigue
26. 26Commentary — Appendix 4 Structural design for fire conditions
27. 27Commentary — Appendix 5 Evaluation of existing structures
28. 28Commentary — Appendix 6 Member stability bracing
29. 29Commentary — Appendix 7 Alternative methods of design for stability
30. 30Commentary — Appendix 8 Approximate analysis
31. 31Commentary — Chapter A General provisions
32. 32Commentary — Chapter B Design requirements
33. 33Commentary — Chapter C Design for stability
34. 34Commentary — Chapter D Design of members for tension
35. 35Commentary — Chapter E Design of members for compression
36. 36Commentary — Chapter F Design of members for flexure
37. 37Commentary — Chapter G Design of members for shear
38. 38Commentary — Chapter H Design of members for combined forces and torsion
39. 39Commentary — Chapter I Design of composite members
40. 40Commentary — Chapter J Design of connections
41. 41Commentary — Chapter K Additional requirements for HSS and box-section connections
42. 42Commentary — Chapter L Design for serviceability
43. 43Commentary — Chapter M Fabrication and erection
44. 44Commentary — Chapter N Quality control and quality assurance