°C: Per Second=Degrees Celsius °F: Per Second=Degrees Fahrenheit NOTE: Per section 4.1.6: The use of M&P that do not comply with the requirements of this NASA Technical Standard may be acceptable in the actual hardware applications. MUAs are required for all M&P that are technically acceptable but do not meet the requirements of this NASA Technical Standard, as implemented by the approved Materials and Processes Selection, Control, and Implementation Plan.
| Per Second | |
|---|---|
| AIAA | American Institute of Aeronautics and Astronautics |
| AM | Additively Manufactured |
| AMS | Aerospace Material Specification |
| ANSI | American National Standards Institute |
| AS | Aerospace Standard |
| ASTM | ASTM International (formerly American Society for Testing and Materials) |
| AWS | American Welding Society |
| BZT | Benzotriazole |
| CCP | Contamination Control Plan |
| CDR | Critical Design Review |
| cm | Centimeter |
| CMH | Composite Materials Handbook |
| COTS | Commercial Off-The-Shelf |
| CP | Commercially Pure |
| CR | Contractor Report |
| CVCM | Collected Volatile Condensable Materials |
| °C | Degrees Celsius |
| °F | Degrees Fahrenheit |
| D | Dimensional |
| DMLS | Direct Metal Laser Sintering |
| DOT | Department of Transportation |
| DRD | Data Requirements Description |
| EDM | Electrical Discharge Machining |
| EEE | Electrical, Electronic, and Electromechanical |
| ELI | Extra Low Interstitial |
| ESD | Electrostatic Discharge |
| ETFE | Ethylene Tetrafluoroethylene |